D-Link DWS-1008 Cli Reference Manual page 402

TxUniPkt
1.0:
2.0:
5.5:
6.0:
9.0:
11.0:
12.0:
18.0:
24.0:
36.0:
48.0:
54.0:
TOTL: 6660 55683 832715 8697520
...
The following table describes the fields in this display:
Field
DAP
Port
radio
LastPktXferRate
NumCntInPwrSave
LastPktRxSigStrength
LastPktSigNoiseRatio
TKIP Pkt Transfer Ct
D-Link DWS-1008 CLI Manual
TxUniByte
TxMultiPkt
1017 0 10170
5643 55683 822545 8697520
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
Distributed AP number.
DWS-1008 port number (if the AP is directly connected to the DWS-1008 and
the DWS-1008 port is configured as an AP access port).
Radio number.
Data transmit rate, in Mbps, of the last packet received by the
DWL-8220AP access point.
Number of clients currently in power save mode.
Signal
DWL-8220AP access point.
Signal-to-noise ratio (SNR), in decibels (dB), of the last packet received by the
DWL-8220AP access point.
This value indicates the strength of the radio signal above the noise floor. For
example, if the noise floor is -88 and the signal strength is -68, the SNR is 20.
If the value is below 10, this indicates a weak signal and might indicate a problem
in the RF environment.
Total number of TKIP packets sent and received by the radio.
RxPkt
TxMultiByte RxByte
0 14 8347
3 1670
0 0 5
0 0 0
0 0 1
0 0 17
0 0 0
0 0 0
0 0 0
0 0 0
0 0 1
0 0 0
41 11513
Description
strength, in dBm, of
UndcrptPkt
UndcrptByte
PhyErr
0 0 3964
0 0 8695
258 0 0 4
0 0 0 51
172 0 0 53
998 0 0 35
0 0 0 26
0 0 0 38
0 0 0 47
0 0 0 1
68 0 0 29
0 0 0 5
0 0 12948
the last packet received by the