Table of Contents
Advertisement
How to Program
To program a Recall button on digital phones:
1 Label a button.
2 Enter programming mode by dialing #33.
3 Press the button you want to program.
4 Dial *89.
5 Continue programming or leave programming
mode by dialing #00.
Recall Timer Interval
DESCRIPTION
CONSIDERATIONS
3-110 MERLIN II System Features
When people use the Recall feature, your MERLIN II system is factory-set to
keep the outside line open for 450 milliseconds, the Recall Timer Interval,
before it accepts the first digit of the next telephone number dialed. If people
in your system are having difficulty using the Recall feature, the Recall Timer
Interval may be incorrectly set. If necessary, you can change the interval to
make it longer or shorter.
If your system has either of the following problems, you should reset the
Recall Timer Interval.
If people try to use the Recall feature and nothing happens, the
interval is too short. Change the setting to 650 milliseconds.
If you have a behind-switch system and people are being disconnected
when they try to use the Recall feature, the interval is too long.
Change the setting to 350 milliseconds.
The Recall feature cannot be used with outside calls if your system has
Automatic Route Selection.
How to Use
To disconnect a call using a Recall button:
1 Press Recall.
To generate a switchhook flash:
1 Press Recall.
2 Press Hold (Pause).
If you have a digital phone and choose to use a
dial code to access the RecaIl feature:
1 Whenever you need to use Recall, dial #50.
Advertisement
Table of Contents
