Recall Timer - AT&T MERLIN LEGEND Release 3.1 System Planning Manual

System Features
!
SECURITY ALERT:
DID numbers that correspond to pool dial-out codes (or facility access
codes) can be used to avoid toll restriction, leading to toll abuse and/or
fraud. (See Appendix A, "Customer Support Information" for more
information about security.)
Planning Form Instructions
Under the Calls to Unassigned Extensions heading on Form 8a, do one of the
following:
To keep the factory setting, check the Extension box.
To change from the factory-set redirect to the primary operator, check
one of the following:
— To redirect calls to a QCC operator (Hybrid/PBX only), check the QCC
queue box and write the extension number in the space provided
(see Form 2a).
— To redirect calls to another telephone, check the Extension box and
write the extension number in the space provided (see Form 2a).
— To redirect calls to a calling group, check the Calling Group box and
write the calling group extension number in the space provided (see
Form 7d).

Recall Timer

This section contains instructions for designating the length of the switchhook
flash sent when Recall is used to disconnect a call and get a new dial tone
without hanging up. The interval of the switchhook flash and how Recall works
depends on the type of telephone being used.
For multiline telephones, the factory setting is 450 ms. If users experience
difficulty with Recall, the interval can be changed to a longer or shorter interval.
The single-line telephone Flash or Recall button transmits a timed switchhook
flash of about half a second.
Planning Form Instructions
Under the Recall Timer heading on Form 8a, check one of the following:
350 ms
450 ms (factory setting)
650 ms
1 sec
4–37
Features