Fcc Notification And Repair Information - AT&T Merlin II Release 3 System Manual

FCC Notification and Repair Information

INTERFERENCE
INFORMATION NOTICE
FCC REGISTRATION AND
REPAIR INFORMATION
Federal Communications Commission (FCC) Rules require that you be
notified of the following:
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions in this
manual and the MERLIN II Communications System Installation,
Administration, and Maintenance Manual, may cause interference to radio
communications.
This equipment has been tested and found to comply with the limits for a
Class A computing device pursuant to Subpart J of Part 15 of FCC Rules,
which are designed to provide reasonable protection against such
interference when the equipment is operated in a commercial
environment.
Operating this equipment in a residential area is likely to cause
interference, in which case the user, at his or her own expense, will be
required to do whatever is necessary to correct the interference.
This equipment is registered with the FCC in accordance with Part 68 of its
rules. In compliance with those rules, you are advised of the following:
Means of Connection: Connection to the telephone network shall be
through a standard network interface jack USOC RJ1lC or RJ14C.
Connection to E&M Tie Trunks requires a USOC RJ2GX. Connection to
Off-Premises Stations requires a USOC RJ1lC. Connection to 1.544 Mbs
digital facilities must be through a USOC RJ48C. These shall be ordered
from your Telephone Company. This equipment may not be used with
party lines or coin telephone lines.
Notification to the Telephone Companies: Before connecting this
equipment, you or your equipment supplier must notify your local
telephone company's business office of the following:
The telephone numbers you will be using with this equipment.
The appropriate registration number and ringer equivalence number
(REN) which can be found on the back or bottom of the control unit as
follows:
If this equipment is to be used as a key system, report number
AS593M-72914-KF-E. If the system provides both manual and
automatic selection of incoming/outgoing access to the network, report
AS593M-72682-MF-E. The ringer equivalence number for both systems
is 0.5A.
For tie line connection provide facility interface code (FIC) TL31M and
service order code (SOC) 9.0F.
For connection to off-premises stations, report FIC OL13C and SOC
9.0F.
FCC Notification and Repair Information 1-3