AT&T Merlin II Release 3 System Manual page 101

To assign labels to lines:
1 Enter administration mode by sliding the T/P switch to P.
2 Press Conference twice.
The administration menu appears.
3 Press
[More], [More],
The system prompts you to designate the type of labels you are assigning.
4 Press
[ L i n e s ] .
The system prompts you to enter the line number.
5 Enter the line number, by pressing the line button or dial the line ID number.
NOTE:
To correct the entry, press backspace then press
6 Press
[Enter]
7 Enter a department name or other label by dialing up to seven characters, including all 26
capital letters, numbers 0 through 9, the ampersand (&), dash (-), space ( ), colon (:),
asterisk (*), and pound sign (#). Figure 3-1 under "Administration Overlay" at the
beginning of this section shows which buttons on the console represent letters and special
characters.
8 Press
[ E n t e r ] .
9 Repeat steps 5 through 8 to assign labels to the remaining lines.
10 Press Conference to continue administration or leave administration mode by sliding the
T/P switch to the center position.
3-72 MERLIN II System Features
Labels can contain up to 7 characters, including capital letters, numbers,
and the special characters listed below under "How to Administer."
A line label can identify the line a call is coming in on but does not
identify the number from which the call is made.
How to Administer
[Label].
[Enter].
(Continued)