Table of Contents
Advertisement
How to Program
This feature requires programming ES Status
buttons at phones and attendant consoles. The
buttons at a phone are used to put it in ES Status
1 or ES Status 2. Attendant consoles can have
buttons that give other phones different ES Status,
including ES Status 0, which is regular call-
handling state.
To program ES Status buttons on MERLIN II
system phones:
1
Label a button.
Enter programming mode by sliding the T/P
2
switch to P. (Digital phones: Dial #33.)
3
Perform the appropriate procedure:
If you're programming a button at a phone
that is not an attendant position, press the
button and dial one of the following codes:
– For ES Status 1: Dial *301.
– For ES Status 2: Dial *302.
If you're programming a button on an
attendant console that changes states at
phones, press the button and dial one of
the following codes:
– For ES Status 0 (Regular call-handling
state): Dial *210.
– For ES Status 1: Dial *211.
– For ES Status 2: Dial *212.
4
Repeat step 3 for each button you want to
program.
5
Program another feature, or leave
programming mode by sliding the T/P switch
to the center position. (Digital phones: Dial
#00.)
To program ES Status on Basic Telephones:
1 Follow the instructions in this section for
"Centralized Programming" and dial the
following codes:
For ES Status 1: Dial # 01*301.
For ES Status 2: Dial # 02*302.
3-58 MERLIN II System Features
How to Use
To monitor and change ES Status from an
attendant console:
1
Check the green light next to the phone's Auto
Intercom button.
Green light off = phone is in ES Status 0, regular call-
handling state.
Green light flashing = phone is in ES Status 1
Green light steady = phone is in ES Status 2
2
If you have buttons programmed to put
phones in ES Status 0, ES Status 1, and ES
Status 2, press the appropriate button.
Otherwise, dial the appropriate code, as
follows:
To put a phone in ES Status 0, dial #35.
To put a phone in the ES Status 1, dial
#36.
To put a phone in the ES Status 2, dial
# 37.
3
Press the Auto Intercom button for the phone
whose status you want to change.
If you hear a denial tone, the phone is currently in use,
has Do Not Disturb turned on, or is in programming
mode.
To
change ES Status from a Basic Telephone:
For ES Status 1: Dial #01.
For ES Status 2: Dial #02.
You can also notify the attendant to change the
ES Status.
Advertisement
Table of Contents
