Table of Contents
Advertisement
How to Program
1 Label a button with lights.
2 Enter programming mode by sliding the T/P
switch to P. (Digital phones: Dial #33.)
3 Press the button you want to program.
4 Dial *72.
5 Leave programming mode by sliding the T/P
switch to the center position. (Digital phones:
Dial #00.)
Recall
DESCRIPTION
CONSIDERATIONS
RELATED FEATURES
You can use Recall to disconnect and then begin another call without hanging
up. When you use the Recall feature, the MERLIN II system is factory-set to
keep the outside line open for 450 milliseconds, the Recall Timer Interval,
before the system accepts the first digit of the next telephone number you
dial.
If your system is behind switch and you have PBX, or Centrex features, or
if you have Custom Calling features on your phone, you must press
Recall (or for digital phones without a Recall button, dial #50, or program
a Recall button) any time instructions call for a switchhook flash. By using
the Recall button, you automatically place a specially timed pause into the
system. If you press the switchhook, you disconnect your call.
The display console has both a Recall button and a Disconnect button. Use
the Recall button to put a switchhook flash in a dialing sequence. You can
press the Disconnect button to disconnect an outside call without hanging
up the handset. Then you can dial a new outside telephone number.
If the Recall Timer Interval is set too long, it may cause the system to
disconnect outside calls. See "Recall Timer Interval" in this section for
details on how to change the interval.
You cannot use the Recall button with outside calls if your system has
Automatic Route Selection.
If you press Recall while on a conference call in which all participants are
connected to the MERLIN II system, the conference is ended, and you are
connected to the intercom line that you last added to the conference. You
will hear a dial tone, and you can place a new call.
The Recall feature will not work over tie lines.
Recall Timer Interval
How to Use
To prevent others from joining your calls:
1 Before placing or receiving a private call, press
Privacy (or dial #31).
If the feature is programmed on a button, the green light
next to the button goes on.
To allow others to join your calls:
1 Press Privacy again (or dial #30).
If the feature is programmed on a button, the green light
next to the button goes off.
MERLIN II System Features
3-109
Advertisement
Table of Contents
