Table of Contents
Advertisement
How to Program
1
Label a button.
2
Enter programming mode by sliding the T/P
switch to P. (Digital phones: Dial #33.)
3
Press the button you want to program.
4
Dial *90 and, if required, a Pool Access
number and two pauses (press Hold twice)
plus a telephone number or a PBX or Centrex
code.
5
You may need to program a pause, stop, or
switchhook flash into an Outside Auto Dial
sequence, or you may need to switch from
rotary to Touch-Tone signals in the middle of a
programmed dialing sequence. To do so, you
must enter the following special characters
when you program the sequence.
To program a pause, press Hold.
To program a stop, press Drop.
To program a switchhook flash at the
beginning of a programmed dialing
sequence, press Recall and then press
Hold.
To program Touch-Tone Enable, press
Transfer.
6
Leave programming mode by sliding the T/P
switch to the center position. (Digital phones:
Dial #00.)
3-102 MERLIN II System Features
How to Use
To dial an outside number with one touch:
1 Without lifting your handset, press the
Outside Auto Dial button for the number you
want to dial.
Your phone speaker goes on and you hear dialing.
2 When you hear the other person answer, lift
your handset or speak into your
speakerphone.
If the line is busy or if no one answers:
1 Perform one of the following steps:
Press Speaker to cancel the call.
Lift your handset and press an Outside
Auto Dial button.
Advertisement
Table of Contents
