C-56 Compaq TaskSmart N2400 Administration Guide
Post QuickRestore and Automated Setup
Upon completion of the restoration, the system is configured as it came from
the factory. The user should follow the same steps of initial setup that were
followed during the initial configuration. Initial setup is identified by two
major phases. These include:
The Microsoft Setup interviews
The TaskSmart Setup utilities
Each of these phases is intended to be fully automated if the configuration
diskette, produced by the Offline Configuration tool, is present in the diskette
drive.
CAUTION: During the setup process, several Microsoft setup screens are
displayed. The user must not interact with the interface that is presented. If the
setup process stops during the Microsoft setup interview for more than 15
minutes, the configuration file can become corrupted or altered in some way.
Power down at the Microsoft setup phase to allow the unit to restart the setup
phase.