Compaq N2400 - TaskSmart - 1 GB RAM Administration Manual page 203

The appliance was configured in the factory with a specific array and logical
drive layout based on the number of installed drives, as shown in Table 6-1.
The array and logical drive setup is based on the listed defaults. When a full
QuickRestore is applied to your system these defaults ease recovery. The
QuickRestore utility uses the same defaults to decide how installed drives are
set up in arrays and logical drives. Refer to Appendix C, "Troubleshooting,"
for more information about the QuickRestore utility.
Number of
Storage Enclosures
1
2
3
4
Advanced Administrative Procedures 6-5
Table 6-1
Data Drive Groups
Number of Drives Drives Lost to
RAID 5 Arrays
4 to 14
15 to 28
29 to 42
43 to 56
Number of
RAID 5 Arrays
1 1
2 2
3 3
4 4