Nc 6132 Nic Leds - Compaq N2400 - TaskSmart - 1 GB RAM Administration Manual

C-40 Compaq TaskSmart N2400 Administration Guide
LED Indication
LNK On
Off
ACT On or flashing
Off
3. Make sure that the switch port and the NIC have the same speed
and duplex settings.
If you configured the NIC for full duplex, make sure the switch port is
also configured for full duplex. Setting the wrong duplex can degrade
performance, cause data loss, or result in loss connections. Also, make
sure that if you are running at 100 Mbps, that the switch supports this
speed.
NOTE: These settings do not apply for the Gigabit Fibre adapters.
4. Reseat the NIC and upgrade module (daughter board).
Open up the unit and reseat both the NIC and the upgrade module
making sure that they are making a good firm connection.
5. Test the network interface controllers using Compaq Diagnostics.
To run the NIC diagnostics you must first install the Network Teaming
utility. Double click the CPQTEAM Setup icon located on the desktop
and follow the installation instructions.
After the utility is installed, the CPQTEAM icon is displayed in the
desktop tray. Double click this icon to run CPQTEAM.
Table C-7

NC 6132 NIC LEDs

Meaning
The NC6132 and hub are receiving power.
The cable connection between the hub and
Gigabit NIC is good.
The NC6132 and hub are not receiving
power, the cable connection between the
Gigabit NIC and hub is faulty, or there is a
driver configuration problem.
The NC6132 is receiving direct packets or
broadcast packets for this specific NIC.
When sending packets, the ACT LED is also
active due to network acknowledgements
received.
The NC6132 is not receiving direct packets
or broadcast packets.