Compaq N2400 - TaskSmart - 1 GB RAM Administration Manual page 298

C-24 Compaq TaskSmart N2400 Administration Guide
Hardware Requirements
You can also run Compaq Utilities remotely over an IPX or IP network using
the Network feature:
To use Compaq Utilities on an IPX network, you must have Compaq
Insight Manager 2.0 or later, or an NVT (Novell Virtual Terminal)
Terminal Emulator with VT100 or ANSI terminal capabilities.
To use Compaq Utilities on an IP network, you must have Compaq
Insight Manager 2.10 or later, or a Telnet Terminal Emulator with
VT100 or ANSI capabilities.
If you are notified that ASR-2 restarted the server and you have restarted to
Compaq Utilities, use the Inspect Utility or Compaq Insight Manager to view
the critical error. Run Diagnostics to diagnose and resolve the problem.
You can configure ASR-2 to restart the server into Compaq Utilities to
diagnose the critical error or to start the operating system to return the server
to operational status as rapidly as possible.
When you enable ASR-2 to start the operating system, the server tries to start
from the primary partition. In this mode, ASR-2 can page you if a critical error
occurs, but you cannot access Compaq Utilities.
When you enable ASR-2 to start Compaq Utilities, the server restarts after a
critical error and loads Compaq Utilities from the Compaq system partition on
the hard drive.
ASR-2 Integrated Management Log Messages
The IML records memory errors, as well as catastrophic hardware and
software errors that cause the system to fail. This information helps you to
quickly identify and correct the problem, thus minimizing downtime.
You can view the IML through Compaq Insight Manager. The Diagnostics
Utility either resolves the error or suggests corrective action in systems that do
not support event logs.
The IML identifies and records all the following errors as defined in
Table C-4.