Compaq N2400 - TaskSmart - 1 GB RAM Administration Manual page 322

C-48 Compaq TaskSmart N2400 Administration Guide
I cannot connect to the board through the NIC.
If you cannot connect to the board through the NIC, try any or all of the
following troubleshooting methods:
Confirm that the green LED (link status) on the board connector bracket
is illuminated. The LED indicates a good connection between the PCI
NIC and the network hub.
Look for intermittent flashes of the green LED. The LED indicates
normal network traffic.
Run the System Configuration Utility to confirm that the NIC is
enabled, and verify the assigned IP address and subnet mask.
From another workstation on the same network, ping the IP address of
the NIC.
Attempt to connect with browser software by typing the IP address of
the NIC as the URL. You can see the Remote Insight home page from
this address.
Reset the Remote Insight Lights-Out Edition board.
Verify that you are using a valid user name and password.
To reset the Remote Insight Lights-Out Edition board, follow these steps:
1. Right-click the My Computer icon of your desktop, and then select
Manage.
2. Expand the Services and Applications folder.
3. Select Services.
4. Stop the Compaq Server Agents service. This action stops the Compaq
Remote Insight Board Configuration agent, the Compaq Web Agent,
and the Compaq Foundation Agents.
5. In Control Panel, select the Compaq Management Agents applet.
6. Select the Remote Insight tab, and then click the Reset Remote Insight
Board button.
7. Restart the Compaq Server Agents service.