Collect Information For Initialization - Compaq N2400 - TaskSmart - 1 GB RAM Administration Manual

Collect Information for Initialization

Collect the general information required to initialize the server for both
dynamic host configuration protocols (DHCP) and non-DHCP configurations.
You will be asked for this information during initialization. Become familiar
with this information before attempting to initialize and configure the server.
Part A: To be completed for DHCP and non-DHCP configurations
Server Host Name:
Remote Insight Board
Name:
Part B: To be completed for non-DHCP configurations only
DNS Servers
1
2
3
Port*
Eth 0
Eth 1
Eth 2
Eth 3
Eth 4
Remote Insight Board
Eth
*The TaskSmart N2400 appliance has five Ethernet ports available for network connectivity. It is
recommended that the four-port network interface controller (NIC) board be used for file services before
using the NIC (Eth 0) port on the system board. Do not configure ports that will not be used. Each
Ethernet port must be configured with a separate subnet.
Note: If NIC teaming is to be implemented, determine which ports will be teamed. Configure these
Ethernet ports for DHCP protocol. For more information refer to the Ethernet teaming features and
procedures section of Chapter 6, "Advanced Administrative Procedures," in the administration guide.
Part C: SNMP Information (optional)
Trap Destination (IP Address) Manager Client
Management Traps Community String
System Management Community String
Remote Insight Board
Default User:
Password:
IP Address
IP Address
Subnet Mask
Initialization 1-3