Diagnostics Software - Compaq N2400 - TaskSmart - 1 GB RAM Administration Manual

C-14 Compaq TaskSmart N2400 Administration Guide

Diagnostics Software

Test Error Codes tables include all test error codes generated by Compaq
products. Each code has a corresponding description and recommended action
or actions. Each system generates only those codes that apply to its
configuration and options.
When you select Diagnostics and Utilities from the System Configuration
Utility main menu, the utility prompts you to test, inspect, upgrade, and
diagnose the server.
Diagnostics and Utilities are located on the Compaq system partition on the
hard drive and must be accessed when a system configuration error is detected
during the Power-On Self-Test (POST). Compaq Diagnostics software is also
available on the Compaq SmartStart and Support Software CD. You can create
a diagnostics diskette from the SmartStart and Support Software CD and run
Diagnostics from diskette. See the procedure in the "Running Compaq
Utilities" section earlier in this appendix.
NOTE: The Enable Drive A: Boot feature must be set before diagnostics can be accessed
from a diskette.
The following options are available from the Diagnostics and Utilities menu:
Test Computer
Inspect Computer
Upgrade Firmware
Remote Utilities
Diagnostic error codes are generated when the Diagnostics software
recognizes a problem. These error codes help to identify possible defective
subassemblies.