Compaq N2400 - TaskSmart - 1 GB RAM Administration Manual page 211

9. In the upper left area of this screen, select (RAID 5) Distributed Data
Guarding, which provides the most efficient fault-tolerant protection
for your data.
Figure 6-6. Create Logical Drive dialog box
10. Be sure that the array accelerator is enabled.
11. Set stripe size to desired value.
12. Set the logical drive size. Use the default values to create a logical drive
that occupies the entire array.
13. Click Done.
14. If you have other arrays, repeat the procedure to create new logical
drives on those arrays as well.
15. You must rescan the drives so that the newly created logical drives are
visible to the operating system. This procedure is accomplished from the
TaskSmart N2400 console. To find the newly created logical drives:
a. Right-click the My Computer icon on the desktop.
b. Select Manage from the menu.
c. Double-click Device Manager.
d. Right-click Disk Drives, and then select scan for hardware
changes.
Advanced Administrative Procedures 6-13