Compaq N2400 - TaskSmart - 1 GB RAM Administration Manual page 190

Accessing the system utilities by pressing F10 during a system restart
a. Select System Configuration.
b. Select Configure Hardware.
c. Select Review or Modify Hardware Settings.
d. Select View or Edit Details.
e. Select Remote Insight Lights-Out Edition board.
f. Change DNS name, network settings or users.
g. Press F10 to save changes before exiting.
Remote Insight Lights-Out Edition board—board configuration service
G
The Compaq TaskSmart N2400 appliance comes equipped with a
Remote Insight Lights-Out Edition board configuration service. The
service is a Windows 2000 service supplied by Compaq. It
configures the network setting for the Remote Insight Lights-Out
Edition board.
G
Initially the Remote Insight Lights-Out Edition board is
preconfigured by the OCU. The Remote Insight Lights-Out Edition
board configuration service is designed to periodically locate the
offline configuration diskette.
G
The Remote Insight Lights-Out Edition board configuration service
locates the diskette. The service then checks for the existence of a
CQNASRIB.CFG file. This file is originally created by the OCU.
G
The service uses the read-only attribute of the configuration file to
determine if the configuration should be applied.
G
On each poll cycle the service checks the read-only attribute of the
configuration file. The poll interval ranges between 1 and 5 minutes.
If the poll range is not set, the service configures the Remote Insight
Lights-Out Edition board and sets a read-only attribute on the
configuration file.
G
To re-enable the offline configuration diskette for Remote Insight
Lights-Out Edition board configuration, the read-only attribute of the
CQNASRIB.CFG file must be reset.
G
For the configuration to occur, the read-only attribute requires that
the offline configuration diskette not be write protected.
G
It is recommended that the OCU be used to enable the offline
configuration diskette. The Remote Insight Lights-Out Edition board
uses the OCU before changing the read-only attribute on the
CQNASRIB file.
Remote Administration 5-7