Figure 19: Srx210 Services Gateway Rack Installation - Hanging The Services Gateway In A Rack - Juniper SRX210 Series Manual

SRX210 Services Gateway Hardware
Related
Documentation
98
Figure 19: SRX210 Services Gateway Rack Installation — Hanging the
Services Gateway in a Rack
Have a second person install a mounting screw into each of the two aligned holes.
6.
Use a number-3 Phillips screwdriver to tighten the screws.
Install the second screw in each mounting bracket.
7.
Verify that the mounting screws on one side of the rack are aligned with the mounting
8.
screws on the opposite side and that the device is level.
SRX210 Services Gateway General Safety Guidelines and Warnings on page 47
Required Tools and Parts for Installing and Maintaining the SRX210 Services Gateway
on page 78
Preparing the SRX210 Services Gateway for Rack-Mount Installation on page 85
Adjusting the Power Supply Adapter Tray for the SRX210 Services Gateway for
Rack-Mount Installation on page 87
Installing the SRX210 Services Gateway on a Desk on page 99
Installing the SRX210 Services Gateway on a Wall on page 100
Copyright © 2012, Juniper Networks, Inc.