Preparing The Srx210 Services Gateway For Wall-Mount Installation; Table 33: Srx210 Services Gateway Preinstallation Checklist For Wall-Mount - Juniper SRX210 Series Manual

Related
Documentation

Preparing the SRX210 Services Gateway for Wall-Mount Installation

Copyright © 2012, Juniper Networks, Inc.
Table 32: SRX210 Services Gateway Preinstallation Checklist for
Desk-Mount Installation (continued)
Task
Verify that you have the following parts available in
your desk-mounting kit to mount the SRX210
Services Gateway vertically:
Vertical stand
Screws
NOTE: If you are mounting the services gateway horizontally on a desk, verify
that the rubber feet are attached to the chassis.
NOTE: The vertical desk-mounting kit is not shipped with the device and
must be ordered separately.
Site Preparation Checklist for the SRX210 Services Gateway on page 37
Clearance Requirements for Airflow and Hardware Maintenance of the SRX210 Services
Gateway on page 41
Unpacking the SRX210 Services Gateway on page 81
Preparing the SRX210 Services Gateway for Rack-Mount Installation on page 85
Preparing the SRX210 Services Gateway for Wall-Mount Installation on page 89
You can mount an SRX210 Services Gateway on a wall. The four rubber feet attached
to the chassis provide stability.
Table 33 on page 89 provides the list of tasks you need to perform before installing the
device.
Table 33: SRX210 Services Gateway Preinstallation Checklist for
Wall-Mount Installation
Task
Verify that the site meets the requirements.
Remove the services gateway chassis from the
shipping carton.
Chapter 12: Installing the Mounting Hardware
Additional Information
Additional Information
"Site Preparation Checklist for the
SRX210 Services Gateway" on page 37
"Unpacking the SRX210 Services
Gateway" on page 81
89