Connecting The Cli At The User End For The Srx550 High Memory Services Gateway; Table 49: Port Settings - Juniper SRX550 Hardware Manual

SRX550 High Memory Services Gateway Hardware Guide
Related
Documentation

Connecting the CLI at the User End for the SRX550 High Memory Services Gateway

112
Connect the other end of the USB cable to the USB console port on the services
4.
gateway (see Figure 24 on page
Start your asynchronous terminal emulation application (such as Microsoft Windows
5.
HyperTerminal), and select the new
software. In most cases, this is the highest-numbered
Configure the port settings, as listed in
6.

Table 49: Port Settings

Port Settings
Bits per second
Data bits
Parity
Stop bits
Flow control
If you have not already done so, power on the services gateway by pressing the Power
7.
button on the front of the services gateway. Verify that the POWER LED on the front
panel turns green.
The terminal emulation screen on your management device displays the startup
sequence. When the services gateway has finished starting up, a login prompt appears.
Log in as the user . No password is required at initial connection, but you must
root
8.
assign a root password before committing any configuration settings.
Configuring the SRX550 High Memory Services Gateway Using J-Web on page 129
Connecting to the SRX550 High Memory Services Gateway from the CLI Remotely on
page 133
To connect to the CLI through a dial-up modem connected to the console port on the
SRX550 High Memory Services Gateway:
Connect a modem at your remote location to a management device.
1.
Start your asynchronous terminal emulation application (such as Microsoft Windows
2.
HyperTerminal) on the management device.
Select the port to which the modem is connected (for example,
3. COM
Configure the port settings shown in
4.
111).
port installed by the USB Console driver
COM
COM
Table 49 on page 112.
Value
9600
8
None
1
None
Table 50 on page 113.
Copyright © 2016, Juniper Networks, Inc.
port in the selection menu.
).
COM1