Connecting To The Cli At The User End For The Srx240 Services Gateway - Juniper SRX240 Hardware Manual

Connecting to the CLI at the User End for the SRX240 Services Gateway

Related
Documentation
Copyright © 2013, Juniper Networks, Inc.
Chapter 12: Connecting the SRX240 Services Gateway to Management Devices
To remotely connect to the CLI through a dial-up modem connected to the console port
on the services gateway:
Connect a modem at your remote location to a management device such as a PC or
1.
laptop computer.
Start your asynchronous terminal emulation application (such as Microsoft Windows
2.
HyperTerminal) on the PC or laptop computer.
Select the port to which the modem is connected (for example,
3. COM
Configure the port settings shown in
4.
Table 27: Port Settings for Connecting to the CLI at User End
Port Setting
Bits per second
Data bits
Parity
Stop bits
Flow control
In the HyperTerminal window, enter
5.
For more information on the AT commands, see the following topics:
Initial Configuration for Security Devices
Monitoring and Troubleshooting for Security Devices
An response verifies that the modem can communicate successfully with the
OK
port on the PC or laptop.
Dial the modem that is connected to the console port on the services gateway by
6.
entering ATDT remote-modem-number
connected to the console port on the services gateway is
.
0013033033030
The services gateway login prompt appears.
Log in as the user . No password is required at initial connection, but you must
7. root
assign a root password before committing any configuration settings.
Connecting to the SRX240 Services Gateway Setup Wizard on page 63
Connecting the SRX240 Services Gateway to the CLI on page 64
Connecting the Modem at the SRX240 Services Gateway End on page 67
Table 27 on page 69.
Value
9600
8
None
1
None
AT .
. For example, if the number of the modem
0013033033030
).
COM1
COM
, enter
ATDT
69