Transmission Features; Stamp; Id Transmission (Closed Network) - Ricoh 3245e Operating Instructions Manual

Chapter2 Page 55 Thursday, January 27, 2000 1:54 PM

Transmission Features

Stamp

Optional Stamp Unit and ADF is re-
quired.
When sending a fax message using
the Document Feeder (ADF), the ma-
chine can stamp a circle mark at the
bottom of the original. Double sided
documents are stamped on the bot-
tom of the front page and top of the
rear page. This indicates that the orig-
inal has been successfully stored in
memory for Memory Transmission,
or that it has been successfully sent
for Immediate Transmission.
Limitation
Stamp only works when scanning
from the Document Feeder (ADF).
When you select the ADF internal
tray, Stamp does not work.
While scanning the document, you
cannot switch stamp on or off.
Do not open the document feeder
(ADF) while scanning the docu-
ment. Document jam should occur.
Note
When the stamp starts getting
lighter, replace the cartridge.
P.244 "Replacing the Stamp Car-
tridge"
Transmission Features
By default, Stamp is turned off. If
you use this feature often, you can
adjust the User Parameters so that
the home setting is on. In this case,
Stamp can easily be turned off for
any single transmission by press-
ing the {Stamp} key.
"Changing the User Parameters"
A
Press the { { { { F5} } } } key.
The Stamp indicator will light.
Pressing the {Stamp} key again
will turn it off.
ID Transmission (Closed
Network)
This feature allows you to restrict
transmission of messages only to ma-
chines of the same make, and only to
those machines that have the same
Polling ID. The transmission options
let you switch ID transmission on and
off for each separate transmission.
Note
The default setting is off. Turn this
feature on with the User Parame-
ters. P.227 "Changing the User
Parameters"
2
P.227
55