Connecting To The Network; Indicators - Ricoh 3245e Operating Instructions Manual

Connecting to the Network

This scanner unit and the network
are connected using 10BASE-T or
100BASE-TX network cable.
A
Confirm that the main power
switch is off.
B
Loop the network cable twice.
The loops should be about 15 cm
(6 inch) from the end of the cable
on the end closest to the connec-
tor.
C
Attach the ferrite core to the
loops.
A
A = 15 cm (6 inch)
D
Connect the scanner unit to the
network hub using the network
cable.
E
Turn on the main power switch.
Note
T h e d e f a u l t I P a d d r e s s i s
"011.022.033.044". Change the IP
address in accordance with the
environment you are using. For
more information about chang-
ing the IP address, see P.11 "Set-
ting Up the Network Environment".

Indicators

There are four LED indicators on the
scanner unit. They can be used to con-
firm that the board is working prop-
erly.
ZATX520E
1.
Indicator (red)
Is on while the network is working.
2.
Indicator (orange)
Is on while Network Interface Board is
working.
3.
Indicator (green)
Is on while using 100BASE-TX. Is off
TACH020E
while using 10BASE-T.
4.
Indicator (green)
Is on while the machine is in a network
environment.
Connecting to the Network
1
2
3
4
ZATH520E
1
7