Ricoh 3245e Operating Instructions Manual page 537

F
Start settings.
• When entering numerical val-
ues, use the number keys. If you
press {#} after entering numeri-
cal values, you can continue to
the next column. < or > can be
also used to change the input
position.
• When selecting items, press [ ]
or [ ] to select items indicated
on the panel.
Note
For more information about the
setting items, see P.18 "Scanner
Setting Items".
To cancel the current settings,
press [Cancel]. The settings re-
turn to the previous values, and
the previous screen appears.
G
Press [OK].
Changed values are saved and the
message displayed in step D ap-
pears.
Note
From this screen, you can also
configure other scanner set-
tings.
H
Press [PrevMenu].
The message displayed in step C
appears.
Note
From this screen, you can con-
figure the network settings and
the image data settings.
I
Press [PrevMenu].
The message displayed in step A
appears.
J
Press [Exit].
The changed settings are saved,
and the message before the set-
tings were made appears.
Important
After pressing [Exit], do not turn
off the machine until the main
menu is displayed, or the set-
tings will not be applied.
Note
The changed settings cannot be
saved until you press [Exit].
These settings also cannot be
saved if the power is turned off
before [Exit] is pressed.
If you press {User Tools/Counter}
while navigating the message
screens, changed settings will
not be saved.
Setting Up the Scanner
2
17