Ricoh 3245e Operating Instructions Manual page 540

Setting Up the Scanner
Delivery option
This setting is necessary to use the
machine as the Network Delivery
Scanner with ScanRouter installed.
When you set "Delivery option" to
"Installed", the following settings
are available. When you set the
"Delivery option" to "Not In-
2
stalled", these settings are not
available.
• Network Settings "7. Delivery
Server Address"
• Scanner Settings "1. Function
Priority", "2. TWAIN connec-
tion time out.", "3. Scanner
Auto Clear Time", "8. Auto Ad-
dress Update", "9. Measure-
ment Unit".
The default setting is "Not In-
stalled".
Important
After changing the settings,
turn the main power switch off
and on. If this is not done, the
new settings will not be applied.
Auto Address Update
When using the machine as the
Network Delivery Scanner, you
can use this function to automati-
cally update the address book (the
lists of addresses and senders).
• When selecting "On", pressing
[Address] while in the Network
Delivery Scanner mode, the ad-
dress saved in the machine is
compared with the one saved in
the ScanRouter Station, and
then it will be updated.
• When selecting
when you turn on the main
power switch, the address is up-
dated.
The default setting is "On".
20
"Off", only
Measurement Unit
You can set the unit of measure-
ment that is shown on the opera-
tion panel when scanning originals
by selecting the area to be scanned
with the Network Delivery Scan-
ner mode.
Select "mm" or "inch".
The default setting is "mm".