Disable Or Re-Enable Output - Panasonic MEW01777 Operating Instructions Manual

Panasonic Eco Solutions Nordic AB
MEW01777 Rev: -
11
Operating Instructions Fire alarm system EBL512 G3, V2.2.x

Disable or re-enable Output

All control outputs (except outputs of type "Alarm devices") can via
menu H2/B2, be individually disabled:
 Loop unit xxxxxx output x
 Control unit xx S0
 Control unit xx R0
 Control unit xx expansion board x output x
This is indicated by LED Fault / Disablements "General
disablements" (L10).
They will remain disabled until they are re-enabled again via menu
H2/B2.
See also chapter "Output type (H2/B3)", page 100.
See also chapter "Activate / Reset outputs (H8/S8)", page 150. An
output can be activated for an output test.
35