Table of Contents
Advertisement
Panasonic Eco Solutions Nordic AB
MEW01777
30.3
Action
"
"
Menu
Scroll to menu H8.
↲
"
"
Scroll to menu S2.
↲
"
"
Rev: -
Operating Instructions Fire alarm system EBL512 G3, V2.2.x
Acknowledge SERVICE signal (H8/S2)
When SERVICE signal is generated in the system, following symbol
is shown in the display's symbol area:
activating SERVICE signal (H4/U5)", page 115.
Sensor = analog smoke detector.
Only 430x, 4400 and 4401 sensors in NORMAL mode have to be
acknowledged:
When service signal from such a sensor is acknowledged, the sensor is
given a default week average sensor value (same as for a new / clean
sensor, i.e. "1" = 0.1 %/m).
acknowledge the service signal as soon as possible. The first week
average sensor value after acknowledge will be calculated within one
hour, then each week.
NOTE! If a sensor 430x, 4400 and 4401 in NORMAL mode is
replaced without having generated service signal, it has to be reset to
the default week average sensor value via menu H8/S3, page 141.
Text in display
H8 Maintenance
S1 Dis- / Re-connect loop / zone line input
S2 Acknowledge SERVICE signal
S3 Clear weekly average
S4 Test of alarm devices
S5 Safe shut down of control unit
S6 Activate address in alarm mode
S7 Synchronize the control units
S8 Activate / Reset outputs
S2 Acknowledge SERVICE signal
Sensor, Zone ZZZ address AA needs service
technical address xxxxxx
2012-12-03 09:09:15
Sensor, Zone XXX address AA needs service
technical address xxxxxx
2012-11-03 19:09:35
Sensor 1/2 is selected
Previous
page
First replace the sensor and then
Next
page
139
See also chapter "Sensors
Comments
According to chapter
"Access", see page 88.
If there are no sensors
--List is empty-- will be
shown. This is a dynamic
list in which you can
scroll. The most recent
service signal / sensor is
shown on top of the list.
Use "▼" or "▲" to select
(t
a sensor
he selected
sensor has a border).
↲
"
"
Press
to
acknowledge the sensor
.
Advertisement
Table of Contents
