Change Password (H10) - Panasonic MEW01777 Operating Instructions Manual

Panasonic Eco Solutions Nordic AB
MEW01777
31.4
Action
" "
Menu
Scroll to menu H10.
↲
" "
↲
" "
Enter the old password,
the new password and
again the new pass-
word.
" ESC "
Rev: - Operating Instructions Fire alarm system EBL512 G3, V2.2.x

Change password (H10)

The password for the person (user name) logged on to the control unit,
can be changed via menu H10 but should normally be changed via
EBLWin, i.e. download of new SSD.
Text in display
H10 Change password
Log in name
Password: 0
New password:
Log in name
Password: ******
New password: ******
Incorrect password, NO change
or
Password changed
▒▒▒ menu
H1 Perform monthly test
H2 Disable or re-enable
H3 Set calendar and clock
H4 Present system status
H5 Service
H6 FAULT Acknowledge
H7 Perform ZONE TEST
H8 Maintenance
H9 Interlocking outputs and inputs
H10 Change password
Escape
menu
As long as you don't close the door you can enter the menu system
again without a password.
NOTE! After change of password it is recommended do a "Safe
shutdown of the control unit" (see menu H8/S5). This will save the
SSW data (e.g. the new password) in a Flash ROM (see page 144).
If the valid password(s) are unknown, EBLWin has to be used to
change the password(s).
Verify:
Verify: ******
157
Comments
According to chapter
"Access", see page 88.
The six digits are replaced
by ****** in the display.
The password is now
changed to the new one.
Scroll to another menu or
press " " or "
ESC Escape
".
menu