Table of Contents
Advertisement
Panasonic Eco Solutions Nordic AB
MEW01777
26.8
Action
"
"
Menu
Scroll to menu H4.
↲
"
"
Scroll to menu U8.
↲
"
"
"
"
ESC
Rev: -
Operating Instructions Fire alarm system EBL512 G3, V2.2.x
Information (H4/U8)
This menu can be used to show the following information for the
specific control unit you currently use:
Main board version
program) version downloaded to the Main board 5010.
MMI board version
program) version downloaded to the MMI board 5011.
Alarm counter The alarm counter is increased with "1" every time
the c.i.e. enters a real "fire alarm condition" (i.e. fire alarm indication
in the display, LEDs "Fire" are lit and the c.i.e. buzzer is sounding).
Alarms from zones in test mode will not be counted. It starts on 000
and goes to 999. It can be reset to 000 via EBLWin (Control unit
menu "Reset alarm counter..."). The value will be retained also after
the c.i.e. has been completely powerless.
Max. number of allowed alarm points that can be used in this
control unit, i.e. 128, 256 or 512. (
Serial number The manufacturer's serial number (year YY, week
WW, number of the main board NNN). Used e.g. when upgrading
max. no. of allowed alarm points.
Control unit number 00-29.
Text in display
H4 Present system status
U1 Disablement
U2 Disablement by time channel
U3 Open doors
U4 Sensor values
U5 Sensors activating SERVICE signal
U6 Technical warning
U7 Event log
U8 Information
U8 Information
Main board version: 2.2.0
MMI board version: 2.2.0
Alarm counter: nnn
Max number of allowed alarm points: xxx
Serial number: xxxxxxx
Control unit: NN
Print
U8 Information
The S/W (software / firmware / system
The S/W (software / firmware / system
Configured number of alarm points.
118
)
Comments
According to chapter
"Access", see page 88.
If printer is mounted the
soft key "
" will be
Print
visible, else not. Press
"
Print
" for a print-out.
Scroll to another menu or
"
"
press
.
ESC
Advertisement
Table of Contents
