Table of Contents
Advertisement
Panasonic Eco Solutions Nordic AB
MEW01777
Rev: -
16.2.1
16.2.3
Operating Instructions Fire alarm system EBL512 G3, V2.2.x
** Fire Alarm **
Zone 002 Address 03
SMOKE
YYYY-MM-DD hh:mm
User definable alarm text
(if programmed)
Reset of the fire alarms, see chapter "Alarm reset", page 53.
Entering the menus during fire alarm
By pressing the soft key "
access to the menu system (see Access, page 88). NOTE! Access
code is required. In this case a part of the display's alarm window will
be temporarily suppressed to permit the display of the menu system.
First alarm: 002-03
Latest alarm: 003-11
menu
H1 Perform monthly test
H2 Disable or re-enable
H3 Set calendar and clock
H4 Present system status
H5 Service
H6 FAULT Acknowledge
H7 Perform ZONE TEST ("Test mode")
H8 Maintenance
H9 Interlocking outputs and inputs
H10 Change password
Escape
menu
The normal alarm window will be automatically displayed again after
the menu system is escaped or 5 minutes after the latest manoeuvre in
the menu system.
The alarm window will also be automatically displayed again if any of
the soft keys "
Esc menu
"Alarms queued" (P8).
Test mode alarm
Regarding Test mode, see chapter "Perform monthly test (H1)", page
91 and chapter "Perform ZONE TEST (Test mode) (H7)", page 134.
When an alarm point in a zone set in test mode is tested, it is presented
in the display as a fire alarm but with the information "Test mode"
21
LED Fault / Disablements "General disablements" (L10) is indicating
that one or more zones / alarm points are isolated (disabled).
45
" (P4) during fire alarm, you will get
Menu
" (P4) or "
ESC
" is pressed or push button
4 zones in alarm
Advertisement
Table of Contents
