14. DISABLE OR RE-ENABLE OUTPUT
All control outputs (except outputs of type "Alarm devices" and "Alarm devices for evacuation") can via menu H2/B2, be individually
disabled:
•
Loop unit xxxxxx output x
•
Control unit xx Sx
•
Control unit xx Rx
•
Control unit xx expansion board x output x
This is indicated by LED Fault / Disablements "General disablements".
They will remain disabled until they are re-enabled again via menu H2/B2.
See also section
28.3. OUTPUT TYPE (H2/B3)
See also section
34.8. ACTIVATE / RESET OUTPUTS (H8/S8)
An output can be activated for an output test, even if it is disabled.
on page 92.
on page 124.
32