Table of Contents
Advertisement
Panasonic Eco Solutions Nordic AB
MEW01777
The zone(s) will stay in test mode until the test mode is ended. The test mode is ended in this menu or
automatically one hour after the latest test alarm. Valid for each zone respectively.
You will be automatically logged out 15 minutes after the latest "action" (using of any key) but the zone(s)
will stay in test mode until the test mode is ended, see above.
Perform the test as quickly as possible, since the output(s) for routing equipment (fire brigade tx) are disabled
(also the parts of the zones in test mode, not visible for the test personnel, are disabled).
In order to shorten the testing time, any time delay for the detectors / zones in test mode will be "disabled",
i.e. fire alarm will be detected faster than normally.
In the tested alarm point, the LED will light up approx. 10 seconds and then the alarm point will be
automatically reset. There will be a test mode alarm indication in the c.i.e. display. The printer, if available,
will print out every tested alarm point (Zone: xxx Address: xx Time: HH.MM).
A detector in test mode is not able to generate a fault.
↲
"
" for each zone to end
the test mode.
"
"
ESC
Rev: -
Operating Instructions Fire alarm system EBL512 G3, V2.2.x
Set in test mode
Zone 000
H7 Perform ZONE TEST
NOTE_1! During the test, the following information will be shown in
all other c.i.e. displays:
Zone 001 in test mode
Zone 002 in test mode
etc.
NOTE_2! If an alarm point (e.g. a manual call point) is in alarm state
when the test mode is ended, there will be a fire alarm activated.
NOTE_3! When the "Fire door closing" function is used, the fire
door will be closed also when the detectors controlling the door are
tested in test mode.
136
No zones in test mode. Set
new zones in test mode or
press "
".
ESC
The LED "Test mode"
(L8) is turned OFF.
If more zones are to be
tested, continue as above.
If not, scroll to another
menu or press "
".
ESC
Advertisement
Table of Contents
