Activate Address Setting Mode For Du (H5/A7) - Panasonic MEW01777 Operating Instructions Manual

Panasonic Eco Solutions Nordic AB
MEW01777
27.7
Action
" "
Menu
Scroll to menu H5.
↲
" "
Scroll to menu A7
↲
" "
↲
" "
↲
" " or " "
ESC
Rev: -
Activate address setting mode for DU
(H5/A7)
This function can be used by commissioning / service engineer to
activate the address setting mode
connected to the c.i.e.:
 Ext. Presentation unit 1728
 Alert Annunciation units 1735 & 1736
 Ext. FBPs 1826 & 1828
A specific unit or all units connected to one c.i.e. can be activated for
address setting.
NOTE! The units have to be in operation and in quiescent condition,
i.e. the units have to have an address already.
Text in display
H5 Service
A1 Calibration of supervised output
A2 Sensitive fault detection mode
A3 Service mode for COM-loop
A4 Display current consumption in control unit
A5 Display current consumption on COM-loop
A6 Display statistics for communication
A7 Activate address setting mode for DU
A8 Setup wireless detectors
A9 SSD information
A7 Activate address setting mode for DU
Activate address setting mode for DU:
Control unit: 00, display unit: 00
Address setting mode for display unit 00,
control unit 00 activated
A7 Activate address setting mode for DU
54
Can as an alternative be done via jumper "J4" inside the D.U. respectively.
Operating Instructions Fire alarm system EBL512 G3, V2.2.x
54
All
128
in the following Display Units
Comments
According to chapter
"Access", see page 88.
Write control unit number,
and the unit's address or
press "►" to select "All"
(i.e. all display units on the
selected control unit).
The address can now be
edited in the display unit
(DU) respectively.
Scroll to another menu or
press "
ESC
".