Upgrade Number Of Alarm Points; Control Units In A Tlon Network - Panasonic MEW01777 Operating Instructions Manual

Panasonic Eco Solutions Nordic AB
MEW01777 Rev: -
20
20.1
Operating Instructions Fire alarm system EBL512 G3, V2.2.x

Upgrade number of alarm points

All EBL512 G3 settings are normally factory downloaded before
delivery. It is however, on site possible to upgrade the maximum
number of alarm points (128  256  512)
NOTE! The maximum number of COM loop addresses is always
1020, i.e. address 1 – 255 on each COM loop.
If you wish to upgrade the number of alarm points, a PC and EBLWin
are used. The PC has to be connected to the USB connector in the
control unit and you have to log on.
MEW01776 (chapter "Upgrade number of alarm points") for more
information.

Control Units in a TLON network

All control units connected to a TLON network do not have to have
the same max. number of alarm points set.
83
See Planning Instructions