Kenwood NX-240 Function Reference page 147

10 FleetSync
10.7 Sending GPS Data
Sending GPS Data Automatically at Certain Intervals (GPS Report Mode)
GPS data can be sent automatically at the intervals configured for GPS Report Interval.
This function is used for position management or monitoring of transceivers on a time base by periodically transmitting
location information to the base station.
To use this function, "Auto" must be configured for GPS Report Mode by using KPG-169D/ KPG-170D/ KPG-175D.
Note
• The transceiver sends the GPS data upon receipt of the GPS data transmission request from the base station even if "Auto" is
configured for GPS Report Mode.
• If the transceiver is under the following conditions, the automatic transmission of GPS data at certain intervals will be canceled. To
avoid a collision with a GPS transmission from other transceivers while sending GPS data, Transmit Busy Wait Time will not suspend
the transmission. (Refer to Transmit Busy Wait Time on page
• While the transceiver is transmitting
• While the transceiver is receiving
• While the Public Address function is used (Mobile only)
• While the transceiver unmutes the speaker
• While Transmit Frequency is not configured
• While transmission is disabled by the Time-out Timer
• While the transceiver is sending or receiving FleetSync data
• While the transceiver is waiting to send the Transpond tone
• Transceiver Password Mode
• Emergency Mode
Configuration using KPG-169D/ KPG-170D/ KPG-175D
Configuring the GPS Report Mode (
Sending GPS Data According to the Request from the Base Station
(GPS Report Mode)
The transceiver can send GPS data when a GPS data transmission request is received from the base station.
This function is used when the base station controls the timing to require GPS data. This function is also used to avoid
transmit collisions if there are many subscriber units.
To use this function, "Poll" must be configured for GPS Report Mode by using KPG-169D/ KPG-170D/ KPG-175D.
Note
The transceiver sends the GPS data to the ID configured for Base Fleet/ Base ID, not to the ID that sent the data transmission request.
Configuration using KPG-169D/ KPG-170D/ KPG-175D
Configuring the GPS Report Mode (
FUNC (K)/Ver 1.20
116)
See Edit > Optional Features > GPS)
See Edit > Optional Features > GPS)
CONTENTS INDEX 122