Kenwood NX-240 Function Reference page 149

10 FleetSync
10.7 Sending GPS Data
Sending GPS Data Together With Status Call (GPS Combination)
The transceiver can send GPS data by adding the GPS data to a Status Message using FleetSync.
To use this function, Status for GPS Combination must be enabled by using KPG-169D/ KPG-170D/ KPG-175D. The
range of status numbers to which GPS data can be added can be configured.
Configuration using KPG-169D/ KPG-170D/ KPG-175D
Configuring the GPS Combination (Status) (
Configuring the GPS Report Status Number Block (
Sending GPS Data Together With Emergency Call (GPS Combination)
The transceiver can send GPS data by adding the GPS data to the Emergency ID (FleetSync).
To use this function, Emergency for GPS Combination must be enabled by using KPG-169D/ KPG-170D/ KPG-175D.
Configuration using KPG-169D/ KPG-170D/ KPG-175D
Configuring the GPS Combination (Emergency) (
GPS Functions
The following functions are relevant to GPS data transmission:
• Number of Times
• GPS Report Interval Time
• GPS Time Mark
• GPS Message Type
• GPS Report on Data Zone-Channel
• GPS Report Back to Requested ID
Refer to 13 GPS FUNCTIONS on page 145
FUNC (K)/Ver 1.20
Status + GPS
Figure 10-7 Timing for GPS Combination (Status)
See Edit > FleetSync > GPS > GPS Combination)
See
Emergency + GPS ID
GPS
Figure 10-8 Timing for Combination (Emergency)
Edit > FleetSync > GPS > GPS Combination)
See
for details of each function.
Transmit
St
GPS
Receive
Edit > FleetSync > GPS > GPS Combination)
Transmit
ID
GPS
Receive
CONTENTS INDEX 124