Table of Contents
Advertisement
14 COMMUNICATIONS IN AN EMERGENCY
14.6 Placing the Transceiver in Emergency Mode Using Lone Worker
14.6
Placing the Transceiver in Emergency Mode Using Lone
Worker
Lone Worker is the function that automatically places the transceiver in Emergency Mode if the transceiver is not operated for
a certain period of time.
If the transceiver is placed in Lone Worker Mode while the user has a task at a dangerous place, for instance, the
transceiver automatically enters Emergency Mode and notifies the base station of the emergency status because a user
cannot operate the transceiver due to an accident.
Since the Lone Worker Tone sounds from the transceiver prior to entering Emergency Mode if the transceiver is in the
Lone Worker Mode, the Lone Worker function can also be used to warn a user.
Placing the Transceiver in Lone Worker Mode/ Exiting Lone Worker Mode
The transceiver enters or exits Lone Worker Mode by a user operating the keys on the transceiver.
Operating the Transceiver
Placing the transceiver in Lone Worker Mode
1
Do either of the following operations while the transceiver is not in Lone Worker Mode:
• Press the Lone Worker key.
• Select a channel where Lone Worker is enabled.
The transceiver enters Lone Worker Mode, and then the timer for Lone Worker Interval starts counting down. The Tone A
sounds from the transceiver by pressing the Lone Worker key. In addition, for Mobile, "Ln" appears on the LED display for 1
sec.
If no key is pressed after the timer for Lone Worker Interval starts counting down, the Lone Worker Tone sounds from the
transceiver when the time configured for Lone Worker Interval elapses. The Lone Worker Tone sounds for the time configured
for Duration of Lone Worker Tone. If no key is pressed while the Lone Worker Tone continues to sound from the transceiver,
and if the time configured for Duration of Lone Worker Tone elapses, the transceiver enters Emergency Mode.
The transceiver behaves according to the configuration of Emergency after the transceiver enters Emergency Mode. (Refer to
14 COMMUNICATIONS IN AN EMERGENCY on page
Note
For Mobile, the transceiver can be configured to light the 2 dots on the LED display (the left dot and the right dot) and the LED (blue)
when Lone Worker is enabled. (Refer to
FUNC (K)/Ver 1.20
149.)
Emergency Mode
Duration of Lone
Worker Tone
Lone Worker
Interval
Transmit (PTT)
Figure 14-4 Lone Worker Mode
5.5 Lighting the LEDs According to the Transceiver's Status on page
Sounds the
Lone Worker Tone
Time
25.)
CONTENTS
INDEX
161
Advertisement
Table of Contents
