Table of Contents
Advertisement
10 FleetSync
10.3 Sending a PTT ID
Timing for Sending the PTT ID
The PTT ID is sent with the following timing:
BOT (Beginning of Transmit)
The PTT ID is added to a signal at the beginning of the transmission.
EOT (End of Transmit)
The PTT ID is added to a signal at the end of the transmission.
Both (BOT and EOT)
The PTT ID is added to a signal at the beginning and end of the transmission.
The timing to send the PTT ID can be configured for each channel by using KPG-169D/ KPG-170D/ KPG-175D.
Configuration
Off
No PTT ID is sent.
Own Fleet (Own) and ID (Own) are sent as the PTT ID when the PTT switch of the transmitting transceiver is
BOT
pressed.
Own Fleet (Own) and ID (Own) are sent as the PTT ID when the PTT switch of the transmitting transceiver is
EOT
released.
Both
Own Fleet (Own) and ID (Own) are sent as the PTT ID at the timing of both BOT and EOT.
The transceiver initiates a Selcall using the FleetSync ID configured in the ID List for FleetSync by pressing the
List
PTT switch on the transmitting transceiver. The FleetSync ID to be sent can be selected from the ID List by using
KPG-169D/ KPG-170D/ KPG-175D. (Refer to
Configuration using KPG-169D/ KPG-170D/ KPG-175D
•
Configuring the PTT ID (Analog) (
•
Configuring the ID List Number of FleetSync ID to be sent (
FUNC (K)/Ver 1.20
PTT
Press
Transmit BOT
Figure 10-1 BOT
PTT
Press
Transmit
Figure 10-2 EOT
PTT
Press
BOT
Transmit
Figure 10-3 Both
Table 10-2 Timing to Send the PTT ID
Edit > Zone Information > Channel Edit > Page 1)
See
Release
Release
EOT
Release
EOT
Description
10.4 Making a Selective Call/ Paging Call on page
Edit > Zone Information > Channel Edit > Page 1)
See
CONTENTS
111.)
INDEX
109
Advertisement
Table of Contents
