Table of Contents
Advertisement
18
FUNCTION PORTS
Supported Models: Mobile
For Mobile, the transceiver is equipped with function ports (AUX Input/ AUX Output) that can be programmed for use with
the D-sub 15-pin connector located on the rear panel of the transceiver.
18.1
Available Functions for AUX Input Ports
Following functions can be assigned to AUX Input ports:
Function Name
None
No function is assigned.
External PTT is the transmission request PTT port for voice channels. This port can be used for a transmission
request from a headset or external microphone. The transceiver starts transmitting if the External PTT port goes low
level. The transceiver ends transmitting if the External PTT port goes high level.
External PTT
Note
If "Data PTT" is assigned to another port, "External PTT" cannot be assigned.
Data PTT is the transmission request port for data communications used in an Analog Conventional system.
The transceiver migrates to an analog channel configured for Data Zone-Channel (Analog) to start transmitting if the
Data PTT port goes low level. The transceiver ends transmitting if the Data PTT port goes high level.
Note
• If "External PTT" or "DTC" is assigned to another port, "Data PTT" cannot be assigned.
• The Data PTT port does not function while the transceiver is in the following modes:
Data PTT
• Scrambler/Encryption Code
• Channel Entry
• Squelch Level
• OST List
• Autodial
• Public Address
• Key functions other than Emergency and LED Brightness do not function while the Data PTT port is active.
FUNC (K)/Ver 1.20
Table 18-1 Available Functions for AUX Input Ports
Description
CONTENTS
INDEX
182
Advertisement
Table of Contents
