Basic Operations; Turning The Transceiver On/ Off; Turning The Transceiver On; Turning The Transceiver Off - Kenwood NX-240 Function Reference

3

BASIC OPERATIONS

3.1

Turning the Transceiver ON/ OFF

Turning the Transceiver ON

Portable
A Power-on Tone sounds from the transceiver by rotating the Power switch clockwise and the transceiver will be turned
ON.
If no data is written to the transceiver when the transceiver is turned ON, the LED lights orange and red alternately and a
Blank Channel Tone continues to sound from the transceiver.
If Transceiver Password is configured for the transceiver, a Power-on Tone sounds from the transceiver when the
transceiver is turned ON, and then the transceiver enters Transceiver Password Mode and the LED lights blue. The
password protection of the transceiver is disabled after the correct password is entered. (Refer to
Transceiver Operation (Transceiver Password) on page
Mobile
Pressing and holding the Power switch causes the transceiver to be turned ON. Also, the transceiver can be turned ON by
linking to the status of the Ignition Sense port of a vehicle. (Refer to
with the Ignition Sense Port Status (Ignition Sense) on page
If no data is written to the transceiver when the transceiver is turned ON, "--" appears on the LED display.
If Transceiver Password is configured for the transceiver, a Power-on Tone sounds from the transceiver when the
transceiver is turned ON, and then the transceiver enters Transceiver Password Mode and "PS" appears on the LED
display. The password protection of the transceiver is disabled after the correct password is entered. (Refer to
Password for Transceiver Operation (Transceiver Password) on page

Turning the Transceiver OFF

Portable
Rotating the Power switch counterclockwise until it clicks turns the transceiver OFF.
Mobile
Pressing the Power switch while the transceiver is turned ON causes the transceiver to be turned OFF. Also, the
transceiver can be turned OFF according to the status of the vehicle engine, either switched On or Off. (Refer to
Turning the Transceiver ON or OFF by Linking with the Ignition Sense Port Status (Ignition Sense) on page
FUNC (K)/Ver 1.20
192.)
19.1 Turning the Transceiver ON or OFF by Linking
188.)
192.)
20.1 Password for
20.1
188.)
CONTENTS INDEX
19.1
9