Tones That Sound When The Communication Starts/ Ends; Using Sound To Notify The Timing To Start Communications (Ptt Proceed Tone) - Kenwood NX-240 Function Reference

6 SOUND

6.3 Tones that Sound When the Communication Starts/ Ends

Alert Tone Pattern
Frequency
Length
Cycle
Interval
Configuration using KPG-169D/ KPG-170D/ KPG-175D
Configuring the Alert Tone Pattern (
6.3 Tones that Sound When the Communication Starts/ Ends
These tones sound when the communication starts or ends and notifies the user of it.

Using Sound to Notify the Timing to Start Communications (PTT Proceed Tone)

PTT Proceed Tone is a tone that sounds from the transceiver when the transceiver becomes available by a user pressing
the PTT switch.
A user must wait to start communications until the transceiver becomes available for communications after pressing the
PTT switch. Since this duration is not always the same, it is difficult for a user to know when to start speaking after pressing
the PTT switch. If a user starts speaking at the time when the PTT Proceed Tone sounds from the transceiver in this
situation, this allows communications to start without losing the first part of the call.
The PTT Proceed Tone sounds from the transceiver if the transceiver can modulate the audio signals after starting
transmission, and the amount of time configured for Proceed Tone Delay Time elapses.
Note
• The transceiver does not transmit audio signals until the PTT Proceed Tone stops sounding even if the transceiver starts transmitting
by a user pressing the PTT switch.
• The PTT Proceed Tone does not sound on a channel in an Analog Conventional system where a PTT ID (DTMF, FleetSync, or MDC-
1200) is configured to be sent when the transmission starts. In this case, a tone sounds from the transceiver according to the
configuration for Sidetone (DTMF/ 2-tone) or PTT ID Sidetone (FleetSync/ MDC-1200).
Configuration using KPG-169D/ KPG-170D/ KPG-175D
• Configuring whether to emit the PTT Proceed Tone (
• Configuring the Proceed Tone Delay Time (
FUNC (K)/Ver 1.20
Table 6-10 Alert Tone Pattern
The tone frequency can be configured. A frequency between 400 Hz and 2500 Hz can be configured in
steps of 10 Hz. Gap can be configured if "No Tone" is selected.
The tone length can be configured. A tone length between 10 ms and 2500 ms can be configured in
steps of 10 ms. No tone sounds if 0 ms is configured.
This function can be used to configure the number of times for the Alert Tone that sounds from the
transceiver. A number from 1 to 255 can be configured. The Alert Tone sounds from the transceiver until
it is manually stopped if "Infinite" is configured. If it is intended for the Alert Tone to sound multiple times,
the Alert Tone does not sound from the transceiver while the transceiver unmutes the speaker. Or, if the
matching state of Optional Signaling is reset, Alert Tone will also be disabled.
This function can be used to configure the timing to repeat the Alert Tone that sounds from the
transceiver. A time between 0 and 255 s can be configured in steps of 1 s.
See Edit > Special Alert Tone)
See
See
Edit > Optional Features > Common 2 > PTT Proceed Tone)
Description
Edit > Optional Features > Common 2 > PTT Proceed Tone)
CONTENTS INDEX 32