Kenwood NX-240 Function Reference page 60

6 SOUND
6.6 Using the Transceiver as a Megaphone (Public Address)
Configuring the Volume Level of Various Tones (Tone Volume)
Supported Models: Mobile
Tone Volume can be used to adjust the volume level of various tones.
This function can be used to maintain the volume level of the tones at a constant level depending on the situation or mute
tones.
Tone Volume of the following tones can be configured using KPG-175D:
• Power-on Tone
• Control Tone
• Warning Tone
• Alert Tone
• Sidetone
• Locator Tone
Following are the types of tone volume that can be configured:
Tone Volume
Current The Tone Volume varies in conjunction with the current volume level.
1 to 31 The tone sounds from the transceiver with a fixed tone volume. Higher values result in greater volume.
Off The tone does not sound from the transceiver.
Configuration using KPG-175D
Configuring the Tone Volume of various tones (
6.6 Using the Transceiver as a Megaphone (Public Address)
Supported Models: Mobile
Public Address enables the transceiver to be used in place of a megaphone.
Pressing and holding the PTT switch while Public Address is enabled causes the audio spoken into the microphone to emit
from the external speaker for Public Address that is connected to the D-sub 15-pin connector of the transceiver rear panel.
Operating the Transceiver
 Enabling the Public Address
1
Press the Public Address
A Tone A sounds from the transceiver and Public Address becomes enabled. "PA" appears for 1 sec on the LED display.
If the 2 dots on the LED display (the left dot and the right dot) and the LED (blue) are configured to light, each LEDs lights while
Public Address is enabled.
 Disabling the Public Address
1
Press the Public Address
A Tone B sounds from the transceiver and Public Address becomes disabled.
FUNC (K)/Ver 1.20
Table 6-11 Available Tone Volume
See Edit > Optional Features > Common 2 > Tone Volume)
key while Public Address is disabled.
key while Public Address is enabled.
Description
CONTENTS INDEX 35