Table of Contents
Advertisement
8 NXDN CONVENTIONAL SYSTEM
8.1 Initiating Voice Communications (Basic Transmission and Reception)
Operating the Transceiver
Enabling the Talk Around
1
Press the
Talk Around
A Tone A sounds from the transceiver and Talk Around becomes enabled.
For Mobile, "tA" appears on the LED display for 1 sec. In addition, if the 2 dots on the LED display (the left dot and the right dot)
and the LED (blue) are configured to light, each LED lights while Talk Around is enabled.
Disabling the Talk Around
1
Press the
Talk Around
A Tone B sounds from the transceiver and Talk Around becomes disabled.
Note
• Talk Around is disabled by changing the zone or channel while Talk Around is enabled.
• Talk Around is disabled in Emergency Mode.
• Even if the Talk Around key is pressed once to disable Talk Around while the Auto Reset Timer is counting down, only Auto Reset
Timer is canceled. To disable Talk Around, press the Talk Around key again after the Auto Reset Timer is canceled. (Refer to
Reset Timer on page
49.)
• For Mobile, the transceiver can be configured to light the 2 dots on the LED display (the left dot and the right dot) and the LED (blue)
when Talk Around is enabled. (Refer to
Configuration using KPG-169D/ KPG-170D/ KPG-175D
Assigning functions to the PF keys (
FUNC (K)/Ver 1.20
key while Talk Around is disabled.
key while Talk Around is enabled.
5.5 Lighting the LEDs According to the Transceiver's Status on page
Edit > Key Assignment)
See
25.)
CONTENTS
INDEX
Auto
54
Advertisement
Table of Contents
