Table of Contents
Advertisement
8 NXDN CONVENTIONAL SYSTEM
8.5 Making a Group Call
Receiving a Group Call
If the received Group ID matches the Group ID configured for the transceiver, the transceiver can receive the Group Call.
Note
To receive a Group Call in an NXDN Conventional system, "NXDN ID" needs to be configured as the Optional Signaling to be used on
the channel. (Refer to
Using the Optional Signaling (NXDN) on page
Transceiver Behavior
1
Receive a Group Call.
An Alert Tone (Group Call) sounds from the transceiver. If Selective Call Alert LED is enabled, the LED blinks orange or blue.
(Refer to
Transceiver Behavior When Receiving a Group Call on this
By pressing the PTT switch while the Auto Reset Timer is counting down, the transceiver can respond (Talkback) with Group
Call to the received Group ID.
Transceiver Behavior When Receiving a Group Call
Alert Tone
If the received Group ID is configured in the Group ID List, an Alert Tone sounds from the transceiver according to the
configuration for Alert Tone of the corresponding Group ID.
However, if "Common" is configured for Alert Tone in the Group ID List, or if the received Group ID is not configured in
the Group ID List, an Alert Tone sounds from the transceiver according to the configuration for Alert Tone (Group Call)
used in common in an NXDN Conventional system.
LED
If the received Group ID is configured in the Group ID List, the LED blinks according to the configuration for Alert LED
Color of the corresponding Group ID.
However, if "Common" is configured for Alert LED Color in the Group ID List, or if the received Group ID is not
configured in the Group ID List, the LED blinks according to the configuration for Alert LED Color used in common in an
NXDN Conventional system.
Note
• When the transceiver receives the Group ID for which "ALL" is configured, the transceiver can respond (Talkback) using the Group ID
if the received Group ID is configured in the Group ID List. If the received Group ID is not configured in the ID List, the transceiver can
receive the call but cannot respond (Talkback).
• The transceiver cannot respond (Talkback) if any key other than the PTT switch is used when the transceiver receives a Group Call.
• For Portable, if any PF key other than the Emergency key is used when the transceiver receives a Group Call, the transceiver reverts
to the normal standby state.
• For Mobile, if the Volume Up, Volume Down, or LED Brightness key is used when a Group Call is received, each of the functions is
activated. In this case, the Alert Tone stops sounding but the LED continues to blink. In addition, if any PF key other than the
Emergency, Volume Up, Volume Down, and LED Brightness key is used when a Group Call is received, the transceiver reverts to
the normal standby display.
Configuration using KPG-169D/ KPG-170D/ KPG-175D
•
Configuring the Alert Tone (Group ID List) (
•
Configuring the Alert LED Color (Group ID List) (
•
Configuring the Alert Tone (Group Call) used in common in the NXDN Conventional system (
Conventional > Alert Tone)
•
Configuring the Alert LED Color (Group Call) used in common in the NXDN Conventional system (
NXDN > Conventional > Alert LED Color)
FUNC (K)/Ver 1.20
55)
page.)
See
Edit > NXDN > Group ID List)
See
Edit > NXDN > Group ID List)
See
Edit > NXDN >
Edit >
See
CONTENTS
INDEX
67
Advertisement
Table of Contents
