Table of Contents
Advertisement
16 SCAN
16.4 Common Functions for Scan
Adding or Deleting a Channel to/from the Target Channels for Scanning
(Scan Delete/Add)
Supported Models: Mobile
Scan Delete/Add is the function to add a channel to the target channels for scanning or delete a channel from the target
channels for scanning.
With this function, a user can reliably receive a call from a primary channel by deleting unnecessary channels to increase
the scan speed.
Following are the transceiver's behavior:
Pressing the Scan Delete/Add key while the transceiver turns Off the scanning adds or deletes a channel to/from the
target channels for scanning.
Pressing the Scan Delete/Add key while the transceiver pauses scanning temporarily adds or deletes a channel to/
from the target channels for scanning. This status is retained until the scanning is terminated by pressing the Scan key
and will be cleared when the scan completes.
An Entry Tone sounds from the transceiver by pressing the Scan Delete/Add key while the transceiver is scanning and
this operation has no effect to the transceiver.
Operating the Transceiver
1
Press the
Scan Delete/Add
If the selected channel is not configured to be scanned, the channel is added to the target channels for scanning. "cA" appears
on the LED display.
If the selected channel is configured to be scanned, the channel is deleted from the target channels for scanning. "cd" appears
on the LED display.
If the 2 dots on the LED display (the left dot and the right dot) and the LED (blue) are configured to light, each LED lights while
Scan Delete/Add is enabled.
Note
The transceiver can be configured to light the 2 dots on the LED display (the left dot and the right dot) and the LED (blue) when Scan
Delete/Add is enabled. (Refer to
Configuration using KPG-175D
Assigning functions to the PF keys (
Revert Channel
Revert Channel is the Zone-channel which is used when the transceiver transmits by a user pressing the PTT switch
during the scan.
Configuration
The transceiver transmits on the last-called Zone-channel by a user pressing the PTT switch during the scan.
The transceiver transmits on the Zone-channel where the transceiver pauses scanning by a user pressing the
Last Called +
PTT switch while the scan pauses.
Selected
If the Zone-channel is changed, the transceiver transmits using the new Zone-channel after the Zone-channel is
changed until the transceiver receives another call.
The transceiver transmits on the new Zone-channel after the Zone-channel is changed regardless of the
Selected
scanning status.
Selected +
The transceiver transmits on the new Zone-channel after the Zone-channel is changed during the scan.
Talkback
The transceiver transmits on the Zone-channel where the transceiver pauses scanning while the scan pauses.
FUNC (K)/Ver 1.20
key.
5.5 Lighting the LEDs According to the Transceiver's Status on page
Edit > Key Assignment)
See
Table 16-2 Revert Channel
Description
CONTENTS
25.)
INDEX
176
Advertisement
Table of Contents
