Kenwood NX-240 Function Reference page 144

10 FleetSync
10.6 Sending a Status Message (Status Call)
*1
The function is not activated for NX-240/ 240V/ 340/ 340U even if the transceiver receives this status.
*2
The functions of Motion Detection, Stationary Detection, and Man-down cannot be used for NX-240/ 240V/ 340/ 340U/ 740H/ 740HV/ 840H/
840HU.
Note
Refer to 10.8 Disabling the Transceiver Capability by Remote Control (Stun/ Kill) on page 125
Status Message on Data Zone-Channel
Status Message on Data Zone-Channel allows the transceiver to automatically change the channel to the Data Zone-
Channel (Analog) to send a Status Message.
The transceiver automatically changes the channel to the Data Zone-Channel (Analog) to send a Status Message. When
the transmission ends, the transceiver restores the Zone-channel which was used for receiving before sending the Status
Message. Status Message on Data Zone-Channel can be used to send data on a specific dedicated channel.
If Data Transmit with QT/DQT is enabled, the QT tone or DQT code configured for the channel can be multiplexed during
data transmission.
Configuration using KPG-169D/ KPG-170D/ KPG-175D
• Configuring the Status Message on Data Zone-Channel to be enabled or disabled (
Parameter)
• Configuring the Data Transmit with QT/DQT to be enabled or disabled (
• Configuring the Data Zone-Channel (Analog) (
Status List
Status Message must be preconfigured in the transceiver using KPG-169D/ KPG-170D/ KPG-175D prior to the
transmission. A maximum of 2 statuses can be configured in the Status List.
The status number between 10 and 99 can be configured.
Configuration using KPG-169D/ KPG-170D/ KPG-175D
Configuring the Status List (
Target Fleet/ ID
Target Fleet/ ID is the target FleetSync ID used for sending a Status Message.
Target Fleet and Target ID can be configured using KPG-169D/ KPG-170D/ KPG-175D. FleetSync ID of the base station
which is responsible for operation and administration is normally configured for Target Fleet/ ID (Status Message).
Configuration using KPG-169D/ KPG-170D/ KPG-175D
Configuring the Target Fleet/ ID (
FUNC (K)/Ver 1.20
See
Edit > FleetSync > Target)
See
See Edit > FleetSync > Target)
Edit > Optional Features > Common 1)
See
Edit > Optional Features > Common 1)
CONTENTS
for details of Remote Stun/ Kill.
Edit > FleetSync >
See
INDEX 119