Table of Contents
Advertisement
9 ANALOG CONVENTIONAL SYSTEM
9.1 Initiating Voice Communications (Basic Transmission and Reception)
Note
For Portable, this function is also activated while the transceiver is transmitting using VOX. For a transmission using VOX, Busy
Channel Lockout will temporarily be disabled and the transceiver can transmit if audio is input within 500 ms after the Warning Tone B
starts sounding from the transceiver.
Configuration using KPG-169D/ KPG-170D/ KPG-175D
Configuring the BCL Override to be enabled or disabled (
Communicating Without Using a Repeater (Talk Around)
Talk Around is the function to communicate directly between transceivers without using a repeater.
If the transceiver cannot link to a repeater due to too great distance between the transceiver and the repeater, the
transceiver can directly communicate with the target transceiver using Talk Around.
The transceiver, with Talk Around enabled, transmits on the receive frequency and uses the Decode Signaling (QT tone or
DQT code) configured for the selected channel.
Operating the Transceiver
Enabling the Talk Around
1
Press the
Talk Around
A Tone A sounds from the transceiver and Talk Around becomes enabled.
For Mobile, "tA" appears on the LED display for 1 sec. In addition, if the 2 dots on the LED display (the left dot and the right dot)
and the LED (blue) are configured to light, each LED lights while Talk Around is enabled.
Disabling the Talk Around
1
Press the
Talk Around
A Tone B sounds from the transceiver and Talk Around becomes disabled.
Note
• Talk Around is disabled by changing the zone or channel while Talk Around is enabled.
• If the transceiver migrates to a data channel by FleetSync GTC, Talk Around is disabled on the data channel. Talk Around will be
enabled if the transceiver returns to the voice channel.
• Talk Around is disabled in Emergency Mode.
• Even if the Talk Around key is pressed once to disable Talk Around while the Auto Reset Timer is counting down, only Auto Reset
Timer is canceled. To disable Talk Around, press the Talk Around key again after the Auto Reset Timer is canceled. (Refer to
Reset Timer on page
114.)
• For Mobile, the transceiver can be configured to light the 2 dots on the LED display (the left dot and the right dot) and the LED (blue)
when Talk Around is enabled. (Refer to
Configuration using KPG-169D/ KPG-170D/ KPG-175D
Assigning functions to the PF keys (
FUNC (K)/Ver 1.20
key while Talk Around is disabled.
key while Talk Around is enabled.
5.5 Lighting the LEDs According to the Transceiver's Status on page
Edit > Key Assignment)
See
Edit > Optional Features > Common 1)
See
CONTENTS
Auto
25.)
INDEX
92
Advertisement
Table of Contents
