Table of Contents
Advertisement
8 NXDN CONVENTIONAL SYSTEM
8.1 Initiating Voice Communications (Basic Transmission and Reception)
Configuration using KPG-169D/ KPG-170D/ KPG-175D
Configuring the Busy Channel Lockout (NXDN) (
Preferentially Using a Channel Being Used by Other Parties (BCL Override)
BCL Override can be used to transmit on a busy channel even if Busy Channel Lockout is activated and transmission is
restricted. This function is used when a top priority transmission is required.
Operating the Transceiver
1
Press the
PTT
switch while transmission is restricted by Busy Channel Lockout.
2
Release the
PTT
switch, then press the
Busy Channel Lockout is temporarily disabled and the transceiver will start transmitting.
Note
This function is also activated while the transceiver is transmitting using VOX (Portable only). For a transmission using VOX, Busy
Channel Lockout will temporarily be disabled and the transceiver can transmit if audio is input within 500 ms after the Warning Tone B
starts sounding from the transceiver.
Configuration using KPG-169D/ KPG-170D/ KPG-175D
Configuring the BCL Override to be enabled or disabled (
Communicating Without Using a Repeater (Talk Around)
Talk Around is the function to communicate directly between transceivers without using a repeater.
If the transceiver cannot link to a repeater due to too great distance between the transceiver and the repeater, the
transceiver can directly communicate with the target transceiver using Talk Around.
The transceiver, with Talk Around enabled, transmits on the receive frequency and uses the Decode Signaling (RAN code)
configured for the selected channel.
Pressing the Talk Around key toggles Talk Around between enabled and disabled.
FUNC (K)/Ver 1.20
See
Edit > Zone Information > Channel Edit > Page 1)
PTT
switch again within 500 ms.
Edit > Optional Features > Common 1)
See
CONTENTS
INDEX
53
Advertisement
Table of Contents
