Kenwood NX-240 Function Reference page 100

Hide thumbs Also See for NX-240:
Table of Contents

Advertisement

8 NXDN CONVENTIONAL SYSTEM
8.8 Communicating using a CW Message
8.8
Communicating using a CW Message
Continuous Wave (CW) is a radio emission type that is used to send and receive Morse code messages over the air.
CW Message is used to send Morse code messages preconfigured in the transceiver by using the PF keys.
Pressing the CW Message key causes the transceiver to send a CW Message.
The transceiver will switch to analog modulation mode when the transceiver sends a CW Message.
A maximum of 32 alphanumeric characters and symbols can be configured and sent.
The CW Message to be sent can be configured using KPG-169D/ KPG-170D/ KPG-175D. The following functions are
relevant to sending a CW Message.
Function
CW Speed
CW Modulation Delay Time
Audio Frequency
CW Sidetone
Note
• A CW message is always sent in analog mode regardless of the configuration for Zone Type.
• CW specifications are compliant with articles in FCC 90.425 Station Identification and International Morse Code.
Configuration using KPG-169D/ KPG-170D
Configuring the various functions of CW Message (
Assigning functions to the PF keys (
Configuration using KPG-175D
Configuring the various functions of CW Message (
Assigning functions to the PF keys (
FUNC (K)/Ver 1.20
Table 8-9 Various Functions of CW Message
CW Speed refers to how fast the CW Message is sent by using Morse code.
CW Modulation Delay Time is the amount of time from when the transceiver starts transmitting until
the transceiver starts sending the CW Message.
PF Key
CW Modulation Delay Time
CW Message
Figure 8-6 CW Modulation Delay Time
Note
If "Off" is configured for CW Modulation Delay Time, the transceiver sends a CW Message
immediately after the transceiver starts transmitting.
Audio Frequency is the frequency used to send the CW Message.
CW Sidetone is the function to emit tones from the speaker while the transceiver sends a CW
Message.
See
Edit > Key Assignment)
See
See
See
Edit > Key Assignment)
Description
Push
Start
Stop
Transmit
Edit > Optional Features > Common 3 > CW ID)
Edit > Optional Features > Common 2 > CW ID)
CONTENTS
Push
Start
Stop
Transmit
INDEX
75

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nx-240vNx-340Nx-340uNx-740hNx-740hvNx-840h ... Show all

Table of Contents