Table of Contents
Advertisement
21
MODE
The transceiver is equipped with Clone Mode to be used for copying the transceiver data to another transceiver and VOX
Gain Level Setup Mode to be used for adjusting the VOX Gain Level.
The transceiver is also equipped with PC Test Mode to be used for testing transmit and receive capabilities of the
transceiver and PC Tuning Mode to be used for adjusting the transceiver by using KPG-169D/ KPG-170D/ KPG-175D.
21.1
Copying the Configuration Data to Another Transceiver
(Clone Mode)
Clone Mode is the mode to copy the data configured for the transceiver to another transceiver by using radio
communications.
Clone Mode is only available for a user with permission to use this mode. Therefore, details for Clone Mode are described
only in the service manual.
Note
For Portable, the cloning is executed by using radio communications in analog mode. For Mobile, the cloning is executed by
connecting the transceivers with a cable.
21.2
Adjusting the VOX Gain Level (VOX Setup Mode)
Supported Models: Portable
VOX Setup Mode is the mode to adjust the input sensitivity of the microphone to be used for the VOX function.
Operating the Transceiver
1
Turn the transceiver ON by pressing and holding the
than 2 sec.
A Tone A sounds from the transceiver, the LED lights orange, and the transceiver enters VOX Setup Mode. Subsequently, the
current value for VOX Gain Level is announced. A Tone B sounds from the transceiver if "Off" is configured for VOX Gain
Level.
Note
• Refer to
17.2 Configuring the Input Sensitivity of the Microphone (VOX Gain Level) on page 179
Setup Mode.
• To exit VOX Setup Mode, the transceiver must be turned OFF.
FUNC (K)/Ver 1.20
Side 1
key and keep holding the
for transceiver operations in VOX
CONTENTS
Side 1
key more
INDEX
195
Advertisement
Table of Contents
